# check for valid lockbox # ddfsadmin lockbox -query # success return code 0 and this output # DD_IP Storage Unit DD_USERNAME DD_Config_Type # 192.168.1.30 Linux-ppdm-01-f3392/PLCTLP-580da36a-9e5d-4bc3-a438-d7d43cf34da4 Linux-ppdm-01-f3392 PROTECTION # failure return code also 0 and this or other output # 2024-01-16T15:30:51.103Z Error retrieving password from lockbox function ppdm_get_config_from_lockbox { # Note: We replace Storage Unit with Storage_Unit so that our read call below can successfully split on space characters :-) local res _h1 _h2 _h3 _h4 res=$( ddfsadmin lockbox -query 2>&1 | \ sed -e 's/Storage Unit/Storage_Unit/g' ) || \ Error "Could not query lockbox:$LF$res" if [[ "$res" != *DD_IP* ]]; then Log "Querying lockbox failed with$LF$res" return 1 fi Log "lockbox result:$LF$res" read -d '' _h1 _h2 _h3 _h4 PPDM_DD_IP PPDM_STORAGE_UNIT PPDM_DD_USERNAME PPDM_DD_CONFIG_TYPE <<<"$res" [[ "$_h1" == DD_IP && "$_h2" == Storage_Unit && $_h3 == DD_USERNAME && $_h4 == DD_Config_Type ]] || BugError "Headings of ddfsadmin lockbox -query differ from what we expect: $_h1 $_h2 $_h3 $_h4" } local start_wait_for_lockbox=$SECONDS waiting=0 found=0 while [[ "$PPDM_DD_IP" == "" || "$PPDM_STORAGE_UNIT" == "" || "$PPDM_DD_USERNAME" == "" || "$PPDM_DD_CONFIG_TYPE" == "" ]] do ((found == 1)) && Error "Could not get PPDM configuration from lockbox even though querying lockbox was successful, check logs" if ppdm_get_config_from_lockbox; then ((waiting == 1)) && ProgressStop let found=1 # continue with the while check to validate that indeed all 4 variables are not empty else if ((SECONDS > start_wait_for_lockbox + PPDM_WAIT_FOR_LOCKBOX_TIMEOUT)); then ProgressError Error "Timeout while waiting for working lockbox" fi if ((waiting == 0)); then LogPrint "Removing old CLB files to allow setting new lockbox" rm -fv $_PPDM_INSTALL_DIR/{agentsvc/config,fsagent/lockbox}/agents.clb* LogPrint \ "PPDM Lockbox not usable, you must go to the PowerProtect Data Manager server and perform the >Set Lockbox< action on the Protection Policy for this system FQDN: $(hostname -f). ReaR recovery can only continue after the lockbox is usable. " ProgressStart let waiting=1 else ProgressInfo "Waiting for $((SECONDS - start_wait_for_lockbox)) of $PPDM_WAIT_FOR_LOCKBOX_TIMEOUT seconds. " sleep 10 fi fi done LogPrint "PPDM recovery configuration: PPDM_DD_IP: $PPDM_DD_IP PPDM_STORAGE_UNIT: $PPDM_STORAGE_UNIT PPDM_DD_USERNAME: $PPDM_DD_USERNAME PPDM_DD_CONFIG_TYPE: $PPDM_DD_CONFIG_TYPE "